Recent Posts

| Forums | Topics

Page 24 / 158 Prev Next

Posts with their shortened content
	RE: Daikin Short Cycle Query By ASHP-BOBBA, 4 days ago Forum Air Source Heat Pumps (ASHPs)
	@treewizard is this not the electrical pulse that keeps the compressor warm? most of these top end builds use around 1kW per day in the winter to either power a heater tape wrapped around the compress...
	RE: Grant 13kW Aerona3 - issues getting zones to temp By Crimson, 4 days ago Forum Air Source Heat Pumps (ASHPs)
	In a way I’m glad the water heating shows this up. As least then its not something beyond the plant room, but perhaps having a bigger LLH further exaggerates what was going on before. Builder said the...
	RE: Grant 13kW Aerona3 - issues getting zones to temp By Crimson, 4 days ago Forum Air Source Heat Pumps (ASHPs)
	Temps quoted refer to: Temp on pipe flowing into house from ASHP (Flow) Temp on pipe just before 2 port valves and thus before the 2 port valve for water heating (Flow after LLH and sec...
	RE: Grant 13kW Aerona3 - issues getting zones to temp By Crimson, 4 days ago Forum Air Source Heat Pumps (ASHPs)
	Also realised hot water tank was sitting at 35C… I do run that to the bare min, 1 cycle a day for an hour. If no one has a shower etc, it will sit lowest 44C, so fine for using. probes show 45C...
	RE: Faulty Clivet heat pump out of the box By benson, 4 days ago Forum Air Source Heat Pumps (ASHPs)
	@steveimpey did you get this sorted in the end with clivet ? (Vested interest as a fellow clivet owner)
	RE: Grant 13kW Aerona3 - issues getting zones to temp By JamesPa, 4 days ago Forum Air Source Heat Pumps (ASHPs)
	Really sorry to hear this, I was expecting no change not a deterioration and I must therefore eat humble pie following my comment that swapping a small volumiser for a larger one wouldn't make things ...
	RE: Grant 13kW Aerona3 - issues getting zones to temp By Crimson, 4 days ago Forum Air Source Heat Pumps (ASHPs)
	Back at (my now colder) house. Barely seen any heating cycles. Realised pressure had dropped to 1 bar, when installers want 1.5. Bled 2 tall rads in downstairs zone, both had a lot of air. Text...
	RE: Daikin Short Cycle Query By TreeWizard, 5 days ago Forum Air Source Heat Pumps (ASHPs)
	I've also got an 8kw Daikin, in the last week I've noticed it oscillating between 350-600W at quite a high frequency for longer periods. Is there some explanation for why it might be ramping up and do...
	RE: Daikin Short Cycle Query By Toodles, 5 days ago Forum Air Source Heat Pumps (ASHPs)
	Herewith a plot of flow rates during the last 36 hour or so. Regards, Toodles. Attachment : IMG_1386.jpeg
	RE: Daikin Short Cycle Query By Toodles, 5 days ago Forum Air Source Heat Pumps (ASHPs)
	I might add that we do have an LLH with a secondary pump (Wilo Pico). Having put temperature probes on all four LLH ports, I have been able to set pump speed to match the primary pump in the Daikin wh...
	RE: Daikin Short Cycle Query By Toodles, 5 days ago Forum Air Source Heat Pumps (ASHPs)
	@ubert767 Just for comparison, here is a plot of my Daikin EDL08 Monobloc system from the last 36 hours or so; the pump is controlled via a Homely smart controller and we heat the whole house to 22.5 ...
	RE: Samsung Gen6 and Havenwise ........ By Alfapat, 5 days ago Forum Air Source Heat Pumps (ASHPs)
	I am no expert on this but on your gen 6 controller once you cahange user set To 0 , then havenwise takes over and I assume that the original settings stay in the back ground. I have just changed my ...