Forums

Forums
Sustainable Sidetra...
DIY
Pergola project
 
Notifications
Clear all

Pergola project

 
DIY
Last Post by Si Fillo 3 years ago
1 Posts
1 Users
0 Reactions
1,870 Views
RSS
Si Fillo
 Si Fillo
(@si-fillo)
Trusted Member Member
Joined: 3 years ago
Posts: 36
Topic starter 09/02/2023 10:07 pm  

Hello everyone! As well as considering my home heat & energy setup after finding this forum, I wondered if anyone could impart any knowledge to my pergola build, in between sorting everyone's heating problems out!

After a couple of summers of not getting around to it, I am determined to get a lean-to-pergola erected this year. My procrastination has mainly been down to a few issues I need to be sure of before commencing. Please refer to attached images.

I want the pergola to cover the entire area of the raised patio which is 5m x 5m with a height of 2.3m to the centre of the 'decorative' brick course.

My idea is for the ledger board to be attached to the garage. I will then have 4 supporting posts (6"x6"?) against the back of

the low wall. My 1st doubt is how to secure the posts and would like advice please.

Posts 1 & 2 have a drain pipe underneath the patio so digging isn't an option. Post 1 can be secured to the bungalow wall IMO.

Posts 3 & 4 could be dug and secured with concrete(?). Post 4 I have concerns as it is right in the corner of the raised patio area and I would suspect that digging will result in the collapse of the immediate earth? (image)

Could Post 2 & 3 be secured with a kind of 'above deck' post bracket? I would suggest a bracket for Post 4 too, but as you can see the paving bricks already seem to be falling away so I have concerns about solid foundations for Post 4 if I went for a bracket.

These 4 posts would support the main beam (2"x8"?) which has a total length of 5m! The gap between posts 1 & 2 and 3 & 4 would be 1m leaving a span of 3m between 2 & 3. There would also be a number of cross rafters from the ledger board to the main beam, which raises more doubts...

1) The main beam: a 5m length of 2x8 will be quite weighty I imagine. Will I need 1 beam or 2 (1 at either side of posts)

2) the 5m rafters will have no support along their span, is this unadvised? i guess the rafters aren't as thick/heavy as the main beam(s) but still, 5m might be a bit of an ask.

-The light post would obv be removed - 
- the low wall would be rebuilt to extend to hide posts.

If anyone is able to offer any advice, it would be appreciated. 🙏

2023 02 09 15h42 36
2023 02 09 15h43 02
2023 02 09 15h43 46
2023 02 09 15h44 16
2023 02 09 15h49 05

 



   
Quote
Forum Jump:
  Previous Topic
Next Topic  
Share:

Join Us!

Podcast Picks

Latest Posts

Click to access the login or register cheese
x Powerful Protection for WordPress, from Shield Security
This Site Is Protected By
ShieldPRO →